Skip to main content
Whoop

About the WHOOP 3.0 LEDs

There are two main sets of Light Emitting Diodes, or LEDs, on the WHOOP 3.0. 

The green sensor LEDs on the bottom of the sensor

The green LEDs on the bottom of the 3.0's sensor are responsible for measuring your heart rate.

If you take off your WHOOP and turn it over to view the sensor, you'll see the green LEDs are lit up. After several seconds of being uncovered, the green LEDs will turn off automatically. 

The white and red LEDs on the top left side of the WHOOP 3.0:

The white and red LEDs found on the side of the 3.0 can be activated by firmly double-tapping the top of the WHOOP sensor.

These LEDs are responsible for communicating the charge level as well as the pairing status of the 3.0.

To check your 3.0's battery level, double-tap on the top of your WHOOP sensor. You should see the LEDs on the top left corner of the WHOOP sensor light up, indicating the battery level:

  • 3 Solid White (LEDs) = 100%
  • 2 Solid White + 1 Blinking White = 80-99%
  • 2 Solid White = 60-79%
  • 1 Solid White + 1 Blinking White = 40-59%
  • 1 Solid White = 20-39%
  • 1 Blinking White = 10-19%
  • 1 Solid Red = 5-9%
  • 1 Blinking Red = 5%

Connection status

  • 1 blinking red and 3 solid white LED indicates that your WHOOP needs to reconnect to the WHOOP App
  • 1 strobing white LED indicates that your WHOOP is in pairing mode

For more information on pairing mode and how it works, check out this article.

  • Was this article helpful?