Changing Bands with the new Fast Link™ Slider

With the WHOOP 4.0’s new Fast Link™ Slider, it’s never been easier to switch out your bands. You’ll never need to thread your band again to wear a new color combination or remove the sensor to place it in your WHOOP Body apparel.

 

IN THIS ARTICLE


Putting on Your WHOOP 4.0 for the First Time:

Your band comes pre-threaded with new Fast Link™ sliders. The first time you put on a new band, you’ll need to ensure it is adjusted to your preferred fit. Once it’s fit to you, you’ll never need to rethread or adjust it again:

  1. Open the clasp with the WHOOP logo facing you
  2. If setting up for the first time, remove the protective film
  3. Slide your 4.0 on and adjust the band so that it sits on your wrist about 1 inch above your wrist bone
  4. Loosen or tighten the fit by gently pulling on the band
  5. For best accuracy, make the band tight enough so that you can’t slide a finger underneath 

Check out our YouTube video to see the Fast Link Slider™ in action:

 

Want to Switch Things Up? Changing Bands with the Fast Link Slider

Your bands will stay threaded and adjusted to your individual fit, unlocking your ability to seamlessly change color combinations as often as you’d like! To change bands, simply:

  1. Open the clasp, slide off the band
  2. Slide in a new one

 

Last updated September 30, 2021

Was this article helpful?
1 out of 1 found this helpful

Comments

0 comments

Article is closed for comments.